Cleaning of the Cell |
1. Switch off chlorinator and pump.
2. Disconnect leads for cell.
3. Remove Cell from Housing. Rounded Housing - Remove
cell from housing by turning anti-clockwise and sliding out.
Square Housing - Remove cell from housing by turning
(aqua colour) locking ring anti-clockwise and remove, then
slide cell out.
4. Clean with a high pressure hose, if this does not remove the
calcium coating, immerse in a solution of 1 part hydrochloric
acid and 10 parts water for up to five minutes, remove and
rinse cell in fresh water. |
Suggested once a year
To clean: refer to the left |
Operation Lights |
The ten green lights positioned in an arc indicate chlorinator is
working. If all ten lights are on, that means the unit is working to
full efficiency at 100%. If output indicator lights are below 100%,
and a higher chlorine level is necessary add salt. If the chlorine
level in the pool is too high adjust the chlorine output knob to,
approx. 80% or until the correct level is achieved.
It is normal in water-for salt level correct & only 6-8 lights on duetcoldwater |
The ten green lights positioned in an arc indicate chlorinator is
working. If all ten lights are on, that means the unit is working to
full efficiency at 100%. If output indicator lights are below
100%, and a higher chlorine level is necessary add salt. If the
chlorine level in the pool is too high adjust the chlorine output
knob to, approx. 80% or until the correct level is achieved. |
